MINOLTA DIALTA DI 1610 DRIVER

User Manual pages. Contact your service representative. Explanation Of Manual Conventions [Copy] key The names of keys on the control panel are written as shown above. Precautions For Routine Use Do not touch or scratch the surface of the toner unit developing roller and the PC drum, as poor image quality could result. Otherwise, manually adjusted reduction make a reduced copy with a ratio. Safety Information This product employs a Class 3b laser diode that emits an invisible laser beam.

Uploader:	Gujas
Date Added:	24 May 2005
File Size:	59.12 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	63149
Price:	Free* [*Free Regsitration Required]

The timer can be set between 1 min and min.

If an incorrect value is entered, press the [No] key, and then enter the correct value. For details on their operation, refer to the pages indicated. The use of non-shielded cable is likely to result in interference with radio communications and is prohibited under CISPR 22 rules and local dialtx.

The image on the copy is not aligned properly. During printing, paper is supplied from the right side of the copier and fed into the Minoltz Tray on top with the printed surface of the page facing down.

Konica Minolta DI Series

Replacing The Toner Cartridge Move the lever in the direction of the arrow to release the lock. Positioning Books Original Glass is bright, it is not a laser beam and, therefore, is not as dangerous. Press the [Yes] key. Power Switch Use to turn the machine on and off. C that was indicated.

Caution Dust that accumulates between the plug terminals may cause a fire. An unpleasant odor may, however, be detected in poorly ventilated rooms during extensive machine operations. The length of time before the machine enters the Energy Save mode can be set between 1 min and min. Page Shake the new Toner Cartridge well. Slide the guide plate to the cialta of the originals. Repeat dialtz 11 and Load the documents removed in step 2 back into the tray.

Enter text from picture: The power source requirements are as follows.

Toner, drums and developer kits for Konica Minolta DI

When The Message "original Doc. Paper loaded into the Bypass Tray is given priority during feeding. The maximum power of the laser diode is 15 mW and the wavelength is nm. For The Bypass Tray Load the desired paper into the tray. Specify the size and type of paper that is loaded.

Konica Minolta Di1610 User Manual

Safety Information This symbol warns against possible causes of burns. Try performing the copy cycle again.

To change the number of copies to be made, remove the paper from the Bypass Tray and then reload it. Use of any supply or consumable not recommended could result in poor image quality and machine breakdown.

Page Load the documents removed in step 2 back into the tray. Dispose of the used Toner Cartridge according to your local regulations.

Konica Minolta DiALTA Di Laser Printer Toner Cartridges

This will start the copy cycle. Note Incorrectly cleaning the Control Panel keys may damage them. Select the setting for the type and du of paper that is loaded. Displays the total number of pages scanned since this machine was installed. Page Do not touch the PC drum under the flap of the Drum Cartridge, otherwise decreased image quality may result.